Dongguan spraying equipment manufacturers analysis of automatic spray gun use mistakes

This article dongguan Maiao spraying equipment manufacturers mainly introduce automatic spray gun use mistakes, if you are interested in it, you can come together to understand. One, mistaken for the spray gun problem

Suddenly there is no atomization, it must be because the atomization pressure is not enough. We can see that the spray gun can eject a straight line at this time, which indicates that the spray gun can still work normally. Then it is the problem of atomization pressure, there are several cases;

1. No atomizing pressure: It comes from different pipelines with the spray gun switch, and there may be no gas in, so check whether the gas is normal and connect the gas.

2. The atomizing pressure is not enough: the power of the air compressor is not enough, resulting in insufficient air pressure. The solution is to have a storage tank, or to change a better air compressor.

3, the air pressure of the spray gun is too large: resulting in excessive gas consumption.

At the same time, no oil also need to consider the air pressure of the spray gun is not enough to shoot the needle. Then we need to look at the above three cases.

Disassemble the air inlet joint of the spray gun

Both automatic spray gun and automatic spray gun have air joints. Many spray guns are coated with thread glue at the thread between the joint and the spray gun. It is easy to damage the spray gun body if it is disassembled by itself. It is necessary to replace other joints, which need to be disassembled under the guidance of the manufacturer.

Three, the flow knob exceeds the limit

In the process of using the spray gun, the flow of the spray gun is too small. When adjusting the flow knob, too much force will lead to the destruction of the spray gun flow knob. Thus causing damage to the spray gun. When the new spray gun is purchased and used, it is necessary to adjust the spray gun flow knob to the position of three to four laps behind the gun.

The above is to explain all the introduction, if you have any questions, you are welcome to consult dongguan Maiao Precision Equipment Manufacturing Co., LTD. Customer service, we will serve you wholeheartedly!